How to Connect Your Devices

1Create Server

Configure a VPS that fits your requirements.

1Log in to your Dashboard and navigate to the Deploy Server page.
2Select a plan.
3Pick the protocol you need.
4Choose a location for your VPN server. (You can change location and protocol later if needed)
5Complete the payment.
6The server will take approximately 10 minutes to configure automatically. Once the Status icon changes from Pending to Ready, your VPN server is ready to use.

2Choose Device

Select the operating system of your connecting device.

3Match Protocol

Pick the same protocol as your server runs.

4Download and install the app

No app available.

5Connection Guide

Connect your macOS device to your OpenConnect server by following the guide.

You may install OpenConnect via Homebrew: formulae.brew.sh/formula/openconnect

However, there is no official app available at the moment for macOS

For command-line usage: Run in Terminal: brew install openconnect

Go to the dashboard

Click "GET VPN ACCESS" on server with OpenConnect protocol

Download certificate and copy Gateway, Username, [Password] from your server access window

Run: sudo openconnect [Gateway]

Enter Username and [Password] when prompted

To disconnect: Press Ctrl+C in Terminal

6Check IP

Confirm your connection by checking your IP.

Open ipaddress.my to confirm the VPN is working correctly. You should see your server's IP address and country there, confirming the connection is active.

Can't find what you're looking for?

Check our support page.

FAQ→